PS1400 Fire Alarm Primary/Secondary 100 Amp Power Supply System
The PS1400 is a pre-engineered, FM approved, Power Supply System that is designed to provide power to fire alarm systems and toxic and combustible gas monitoring systems. Each system consists of a 24 Volt Battery Set and a charger system that has been FM approved to be compliant with the NFPA 72 requirements for primary and secondary power supplies.
The system is comprised of two main components, the Battery Charger Panel and the Battery Set.
Battery Charger Panel Features
The Battery Charger performs several functions: 1) it charges the Battery Set 2) it provides unregulated power for powering field circuits, and 3) it powers one or two DC-DC converters (if equipped) that provide system regulated power. The Battery Charger monitors its own health as well as that of the AC feed and the battery voltage, and provides individual status contacts that can be wired to a Fire alarm panel for indication and alarming. A fused disconnect between the battery charger and battery set is provided. A means for detecting a disconnected battery condition is provided by using a current shunt to measure the charge current being supplied to the Battery Set. If this current drops below a minimum threshold, the Battery Set is assumed to be disconnected. If the charger output fails, current flow will reverse as the Battery Set begins to provide system power.
Battery Set Features
The Battery Set is provided as a secondary power supply as required by NFPA 72. The Battery Set is floor mounted and self-contained, i.e. it does not have to be mounted in an enclosure. Plastic guards are provided to protect the terminals from damage or shorting.
The DC-DC Converter(s) provide a tightly regulated 24 VDC nominal output. Regulated power is used for those components and circuits that require tight voltage regulation and where ground fault detection is not required. A separate ground fault detection circuit is provided for unregulated power, for alarming and reporting to a Fire and Gas alarm panel. Separate regulated and unregulated 24 VDC circuits including a disconnect means and over-current protection are provided for powering the Fire and Gas alarm panel.